JVC LPT0617-001A Enter the programme mode, Set the programme start/stop time and channel

40 TIMER RECORDING (cont.)

24 Hour Express Timer Programming

Before performing the 24 Hour Express Timer Programming:

●Make sure that the recorder’s built-in clock is set properly.

●Set the tape speed.

●Select the deck.

●For the VHS deck:

Insert a VHS (or S-VHS) cassette with the record safety tab intact.

For the DV deck:

Insert a Mini DV cassette with the erase protection switch set to “REC”.

You can programme a timer recording that starts within 24 hours using the JOG dial on the recorder.

A Enter the programme mode.

Press 24H EXPRESS # on the recorder. The start time indicator ( ) starts blinking on the front display panel.

●The current tape speed and VPS/PDC setting appear on the front display panel, but it is impossible to change the setting.

You can only change the setting after programming ( pg. 42).

B Set the programme start/stop time and channel.

Turn the JOG dial to the left or right to set the time you want recording to start.

●One click stop of the JOG dial changes the time in 5-minute intervals.

1 3 2

Push the JOG dial. The stop time indicator ( ) starts blinking on the front display panel. Turn the JOG dial to the left or right to set the time you want recording to stop.

Push the JOG dial. Turn the JOG dial to the left or right to select the channel you wish to record.

●You can cancel the setting at any time by pressing and holding the JOG dial for more than 3 seconds or pressing & on the remote control. Repeat the step 2.

C Engage the recorder’s timer mode.

Press 24H EXPRESS #. The recorder turns off automatically and “#” appears on the front display panel.

●To disengage the timer mode, press # (TIMER) or 24H EXPRESS # again.