Korg Trinity ProX, Trinity Plus manual Program Drums OSC mode, + + Se nd2

Overview

If output connectors 3 and 4 are used for stereo output, you can set the stereo position of Send 1 and 2 using the Pan 3 and 4 parameters (P8 in Program Edit mode).

To set the Master Effect return level, use the Return 1 and 2 parameters (P8 in Program Edit mode).

If you check the check box located between Send 1 and Send 2 in the upper left corner of the LCD, the serial routing of Modulation → Reverb/Delay will be added. That is, the Right modulation output will be added to the Reverb/Delay input. In this case, you can still set the Return 1 and 2 parameters indepen- dently.

Program - Drums OSC mode

DrumKit					Insert Effects			Master Effects
(Global P5)			Amp1/2 Mod		(Program Edit P7)			(Program Edit P8)
Insert Effect=Off			(Program Edit P5)				Master Effects	Pan1
	+		Send1		+		Modulation		OUT3
Send1
					+
	+		Send2				Reverb/Delay
Send2									OUT4
								Pan2
Kick
Pan					+
	+		Insert	Send1			Return2	Return1
					+
Send1			Effects
Send2	+			+ + Send2		+	+	LEQ	HEQ
								+	OUT1
	+		E1
Snare						+	+	+
				Send1					OUT2
Pan	+				+
						Pan Width
Insert Effect=inst1					+
Insert Effect=inst2		->E1/E2/E3/E4		+ + Send2		+		Low Gain High Gain
	+		E2
Send1						+
	+			Send1	+
Send2
						Pan Width
	+				+
Tom				+ + Send2
Pan	+	Inst1/2/3/4				+
			E3
	+					+
Send1				Send1
	+
						Pan Width
Send2
				+ + Send2
H.Hat	+					+
Pan	+		E4
Insert Effect=inst3						+
						Pan Width
Send1
Send2
Conga	+
Pan	+
Insert Effect=inst4

Insert Effect=Off

Insert Effects

Program - Drums OSC Mode

You can insert up to four effects in series or parallel as long as the total of the effect sizes is four or less when you are using a Drum mode Program (shown as E1, E2, E3, and E4 in the center of the figure above).

You can select Insert On/Off, and inst 1–4 (using E1–E4 input), and set the Pan and Send 1/2 parameters for each Drum sound in P5 of Global mode for each key. The final send setting will use the value set here multiplied by the Send setting set in P5 of Program Edit mode.

If you insert a size 1 effect, the input/output becomes monaural. In this case, the DrumKit’s Pan parame- ter (P5 in Global mode) becomes ineffective, and the sound will be panned in the center. Adjust the stereo position using the Pan parameter (P5 of Program Edit mode) that comes after the Insert Effects (P7 in Pro- gram Edit mode).

If the Insert Effect output is in stereo, you can control the width of the effect (such as the width of rever- beration) using the Width parameter (P7 in Program Edit mode). If you wish to make the DrumKit’s Pan setting (P5 in Global mode) effective, set the Pan setting that comes after the Insert Effects to C064 and set the Width to 127.

Master Effects

The input level of the Master Effects is set by Send 1 and 2.

Since the destination of the send routing changes depending on whether the Insert Effects have been inserted or not, the parameters will change accordingly.

5