Overview
Effect Size
Insert Effects utilize effect sizes of 1, 2, and 4.
Program (Single or Double mode Program):
Up to three effects with a total effect size of four or less can be inserted in series.
Size | Size | Size |
1 | 1 | 2 |
Program (Drum mode Program):
Up to four effects with a total effect size of four or less can be inserted in series/parallel. Use P5 (DrumKit) in Global mode to assign the DrumKit sounds to Insts
Inst1
Inst2
Inst3
Inst4
Size |
1 |
Size |
1 |
Size |
1 |
Size |
1 |
Inst1
Inst2
Size |
2 |
Size |
2 |
Inst1
Size
4
Inst1 | Size | Size |
| 1 | 1 |
Inst3 | Size |
|
1 |
| |
|
| |
Inst4 | Size |
|
| 1 |
|
Combination:
Up to eight effects with a total effect size of eight or less can be inserted.
Timbre1
Timbre2
| Size |
|
| 4 |
|
Size | Size | Size |
1 | 1 | 2 |
Timbre1
|
|
|
|
|
| Size | Size | Size |
|
| 4 | 2 | 2 |
|
|
|
|
|
|
|
|
|
|
|
Sequencer:
Up to eight effects with a total effect size of eight or less can be inserted.
Track1 |
| Size | Track1 | Size | Size | Size |
| 4 | 4 | 2 | 2 | ||
|
|
| ||||
Track2 | Size | Size | Size |
|
|
|
| 1 | 1 | 2 |
|
|
|
Effect Input/Output
The following table shows the input/output of the Dry sound (the sound without any effect applied) and the Wet sound (the sound with an effect applied) for each size.
size1 | Dry | Mono In - Mono Out | Effect | |
Wet | Mono In - Mono Out | |||
|
| |||
| Dry | Stereo In - Stereo Out | Effect | |
| Wet | + | ||
| Mono In - Mono Out |
| ||
size2 | Dry | Stereo In - Stereo Out | Effect | |
size4 | Wet | + | ||
Mono In - Stereo Out |
| |||
| Dry | Stereo In - Stereo Out | Effect | |
| Wet | Stereo In - Stereo Out | Effect |
Shown on the upper left corner of the effect block diagrams.
The Size 1 effects are all monaural in/monaural out for both dry and wet sounds. Therefore, Size 1 effects have monaural input as shown in the figure on the next page. If the Effect On/Off parameter is turned Off, the effect is bypassed. When a size 1 effect is selected, the bypass sound becomes monaural.
Regardless of the Effect On/Off setting, you can turn all Insert Effects Off by sending the Effect 2 Control message (Controller #92). When the Controller value is 0, all effects turn Off. They turn On with a value of
2