
02: Limiter
Limiter - Threshold / Ratio
Output Level
| Ratio=1.0 : 1 |
| Ratio=2.0 : 1 |
Threshold | Ratio=4.0 : 1 |
| |
| Ration=Inf : 1 |
Louder |
|
| Louder |
| Input Level |
Level | Ratio=1.0 : 1 | |
Dry | ||
Ratio=2.0 : 1 | ||
| ||
| Ratio=4.0 : 1 | |
| Threshold | |
| Ratio=Inf : 1 | |
| Time |
c: Attack | These parameters set the attack time and release time. A higher attack time will |
d: Release | cause the compression to be applied more slowly. |
| Limiter - Attack / Release |
| Threshold |
| Dry |
Ratio=Inf : 1
WetAttack=1
Release=1
Ratio=Inf : 1
WetAttack=100
Release=100
Release
Attack
f:Side PEQ Insert
g:Side PEQ Cutoff [Hz]
g:Q
g:Gain [dB]
h:Trigger Monitor
These parameters are used to set the EQ applied to the trigger signal.
The Limiter determines whether the compression is applied or not, based on the sound
Setting this parameter On will cause the trigger signal to be output, instead of the Limiter signal. Use this parameter to check the trigger signal with EQ applied.
Usually, set this to Off.
16