Connection/Installation
Mounting the Camera
Selecting a Mounting Method
The procedures vary according to the mounting method. Mount the camera accordingly by referring to the respective section.
Note:
●Be sure to put on protective glasses to protect your eyes from falling objects when mounting the camera to the ceiling.
●To mount the camera using an electrical box, please consult the dealer shop from which the camera is purchased or any nearby JVC Service Centers.
Mounting Methods
Embedding into the ceiling (A page 10)
Mounting directly to the ceiling or the wall (A [READ ME FIRST])
Mounting with the cables pulled out from the side (A page 12)
Warning
●Special attention is required when mounting the camera to a wall or ceiling. Make sure that the mounting work is performed by a specialist. Improper mounting may cause the camera to fall off and result in injuries.
●We are not liable for any damage, injury or other problems caused by a camera that has fallen off due to failure to follow the installation instructions and improper mounting. Pay careful attention during mounting.
●To prevent the camera from falling off, mount it to a firm place (ceiling slab or channel) using a fall prevention wire.
●Take note of the length, strength, pull and material (insulation) of the fall prevention wire.
●Insufficient tightening of the mounting screws and nuts may cause the camera to fall off. Make sure that there are properly and firmly tightened.
●Do not mount the camera near lighting equipment that may be heated up to a high temperature, such as a spotlight. This may result in malfunction of the equipment or cause fire.
Embedding the Camera into the Ceiling
TThe camera can be mounted to ceilings with a thickness between 9.5 mm and 22 mm.
Preparation
1 Make a hole in the ceiling (R120 mm)
2 Pull out the cables from the hole in the ceiling
Pull out the fall prevention wire, LAN cable, power cable, alarm cable, and audio cable that are attached to the ceiling slab from the hole. (Fall prevention wire is not provided)
Note:
●Take note of the length, strength, pull and material (insulation) of the fall prevention wire.
●The inner diameter of the ring section of the fall prevention wire to be mounted to the camera should be betweenR3.1 mm and R5.5 mm, and the outer diameter not larger than R9 mm.
1R120 mm
Fall prevention wire (Not supplied) 
Cables (power cable,
Approx. 100 mm alarm cable, audio
cable, etc.)
LAN cable | 2 |
|
3 Remove the dome cover
Turn the dome cover in the
Dome cover 
protective sheet
10