Q Tilt fastening screw
Note:
●After adjusting the field angle, tighten the tilt fastening screw to secure the camera so that its field angle does not go out of alignment.
(A [READ ME FIRST])
R Focus adjustment ring
Move the ring to the left and right to adjust the focus.
(A [READ ME FIRST])
S Zoom adjustment ring
Move the ring to the left and right to adjust the field angle.
(A [READ ME FIRST])
T [MONITOR] terminal (pin jack)
(A [READ ME FIRST])
U [RESET] button
This button has two functions as described below, depending how it is being pressed.
●Reset function (press for less than 2 seconds and release)
Reboots the camera. Reboot takes about 1 minute. During this interval, the [RESET] button is disabled.
●Focus adjust function (press for at least 2 seconds and release in less than 5 seconds)
The camera enters the focus adjust mode and the status indicator V blinks in green and orange alternately.
This function can also be used on the viewer. Refer to [INSTRUCTIONS (Setting)].
Note:
●During the focus adjust mode, the screen may flicker when the electronic shutter is operating. This is not a malfunction.
●Pressing this button for 5 seconds or longer switches the camera to the Service Check mode. The status indicator lights up in orange color in this mode. Do not press the button for 5 seconds or longer.
●To make use of the focus adjust function of the Reset button, restart the camera after
setting the [MONITOR OUT] output selection switch W to ANB or APB.
8