EN 65

Audio Dubbing

The audio track can be customized only when recorded on the 32 kHz mode (pg. 35).

NOTE:

Audio Dubbing is not possible on a tape recorded at 48 kHz, on a tape recorded in the LP mode or on a blank portion of a tape.

6e

Remote sensor

 

External microphone

MIC

input connector

 

 

(Located beneath

 

 

the cover.)

Stereo microphone

 

 

 

DC-IN

 

Audio Dub Standby

Power Dial

Speaker

RM-V711U (provided)

T W

DISPLAY AUDIO MONITOR A.DUB

PLAY

PAUSE

STOP

1 FIND EDIT-IN POINT

Play back the tape to locate the point where editing will start, then press PAUSE.

2 ENGAGE AUDIO DUB STANDBY While holding A. DUB on the remote control, press PAUSE. “6e” appears.

NOTES:

3 BEGIN DUBBING

Press PLAY, then begin “narrating”.

•Speak into the microphone.

4 PAUSE DURING DUBBING

Press PAUSE.

5 STOP DUBBING

Press STOP.

Audio dubbing is possible using an optional microphone connected to the external microphone input connector (MIC).

While an optional microphone is connected, the built-in microphone is disabled.

When editing onto a tape that was recorded at 32 kHz, the old and new soundtracks are recorded separately.

To select the desired sound for playback, press AUDIO MONITOR on the remote control.

If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

If feedback or howling occurs during TV Playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

Sound is not heard from the speaker during Audio Dubbing. To hear sound, connect optional headphones to the AV-OUT (headphones) jack.

If you change from 32 kHz to 48 kHz in mid-recording and then use the tape for Audio Dubbing, it is not effective from the point where 48 kHz recording began.

During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded at 48 kHz or a blank portion, Audio Dubbing stops and “ERROR! REFER MANUAL” appears.

RECORDING SOUND

DISPLAY

OUTPUT SOUND

32 kHz

FULL SOUND

Original and new tracks are combined and output in stereo.

 

SOUND 2

New track is output on both “L” and “R” channels in stereo.

 

SOUND 1

Original track is output on both “L” and “R” channels in stereo.

 

 

 

Page 65
Image 65
JVC 0797TOV*UN*SN, LYT0002-0R1A manual Audio Dubbing, Find EDIT-IN Point, Begin Dubbing, Pause During Dubbing, Stop Dubbing