JVC LYT1147-001A manual 64 EN, Items

64 EN				DETAILS
ITEMS		NOTES
V Power ( pg. 10)	● Perform charging where the temperature is between 10°C and 35°C. 20°C to 25°C
	is the ideal temperature range for charging. If the environment is too cold,
	charging may be incomplete.
	● Charging times are for a fully discharged battery pack.
	● Charging time varies according to the ambient temperature and the status of the
	battery pack.
	● To avoid interference with reception, do not use the AC Power Adapter/Charger
	near a radio.
	● Since the AC Power Adapter/Charger processes electricity internally, it becomes
	warm during use. Be sure to use it only in well-ventilated areas.
V VIDEO	● When you use the LCD monitor outdoors in direct sunlight, the LCD monitor may
RECORDING	be difficult to see. If this happens, use the viewfinder instead.
( pg. 17)	● The cassette holder cannot be opened unless a power supply is attached.
	● There may be a delay after you open the cassette holder cover until the cassette
	holder opens. Do not use force.
	● Once the cassette holder is closed, it recedes automatically. Wait until it recedes
	completely before closing the cassette holder cover.
	● When the Recording Start/Stop button is pressed, it may take a few seconds before
	actual recording starts. The “T” indicator starts rotating when the camcorder
	actually starts recording.
	● The time required to calculate and display the remaining tape length, and the
	accuracy of the calculation, may vary according to the type of tape used.
	● “TAPE END” appears when the tape reaches its end, and the power goes off
	automatically if left in this condition for 5 minutes. “TAPE END” also appears
	when a cassette at its end is loaded.
	● During recording, sound is not heard from the speaker. To hear the sound, connect
	optional headphones to the headphone connector. The sound volume is at the
	level it was adjusted to during playback. ( pg. 20)
	● During Interface Shooting, the “Tape Running” indicator and warning indications
	( pg. 80, 81) are the only ones that are shown; they appear reversed in the
	display as they would when viewing a mirror, but are not reversed in the
	recording.
	● The tape remaining indicator does not appear during interface shooting. However,
	when the remaining time reaches 2 minutes, the indicator appears showing the
	remaining time:	(blinking)	(blinking)	(blinking)