JVC LYT1147-001A Updating Device Manager Windows, Click the next three items in the order below

Installing USB Video Streaming driver for Windows® XP users

When you connect the camcorder to the PC, four drivers are installed in succession by following the procedures below.

NOTES:

Click [Continue Anyway] when the message [Has not passed Windows Logo testing] appears. Be sure not to select [Stop Installation]. If you do so, the USB Video Streaming drivers will not be installed correctly.

1Connect the camcorder to the PC with a USB cable.

After a moment, the [Found New Hardware Wizard] screen appears.

●Refer to “Connecting the USB cable” (
pg. 9).

2Click [Install from a list or specific location (Advanced)] and then click [Next].

The driver search screen appears.

3Click the next three items in the order below.

●[Search for the best driver in these location]

●[Include this location in the search]

●[Browse]

4Double-click [My Computer] on the desktop.

5Double-click the CD-ROM drive icon and the [XP] folder, and then click [OK].

6Click [Next].

●The warning message dialog box appears.

7Click [Continue Anyway].

After a moment, the [Found New Hardware Wizard] screen appears.

8Click [Finish].

After a moment, the [Found New Hardware Wizard] screen appears again.

9Repeat steps 2 to 8 until the [Found New Hardware Wizard] screen is cleared.

After you repeat steps 2 to 8 four times, the installation of the USB Video Streaming driver is complete.

Updating [Device Manager] (Windows®)

If the camcorder is connected to the PC with the USB cable before installing [USB Mass Storage Class driver] or [USB Video Streaming driver], the installation might not be performed properly.

In this case, follow the procedure described below to update the [Device Manager] and install [USB Mass Storage Class driver] and [USB Video Streaming driver] properly.

NOTE:

Disconnect any other USB audio devices from PC before performing the following procedure.

Installing [USB Mass Storage Class driver] (Windows® 98/98SE only)

1Use the USB cable to connect the camcorder to the PC. (
pg. 9)

2Select [Start] – [Settings] – [Control Panel]. Double click the [System] icon.

3Select the [Device Manager] tab.

4Delete [GR-DVP9*] in [Other devices].

*The model name depends on the connected camcorder.

5Disconnect the USB cable from the camcorder. Restart the PC.

— 8 —

CONTINUED ON NEXT PAGE