EN 9
Master Page: Right-start
AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when “DEMO
MODE” is set to “ON” (factory-preset).
䡲Automatic Demonstration starts when there is no
operation for about 3 minutes after the Power
Switch is set to “A” or “M” and no cassette is in
the camcorder.
䡲Performing any operation during the
demonstration stops the demonstration
temporarily. If no operation is performed for more
than 3 minute after that, the demonstration will
resume.
䡲“DEMO MODE” remains “ON” even if the
camcorder power is turned off.
To cancel Automatic Demonstration
1Set the Power Switch to “M” while pressing down
the Lock Button located on the switch.
2Open the LCD monitor fully, or pull out the
viewfinder fully.
3Press MENU. The Menu Screen appears.
4Press + or – to select “sSYSTEM”, and press
SET/SELECT. The SYSTEM Menu appears.
5Press + or – to select “DEMO MODE”, and press
SET/SELECT. The Sub Menu appears.
6Press + or – to select “OFF”, and press SET/
SELECT.
7Press + or – to select “BRETURN”, and press SET/
SELECT twice. The normal screen appears.
NOTE:
Slide the lens cover down to see the actual changes
of the Automatic Demonstration activated on the
LCD monitor or viewfinder.
Automatic Demonstration
ST
M SY E
DEM– MO DE O
NO
OFF
Power Switc h
Lock Button
MENU Button
Sub Menu
SET/SELECT Button +,– Button
GR-DVP9Asia.book Page 9 Monday, February 10, 2003 1:12 PM