JVC LYT1147-001A manual Insert Editing

EN 57

1 Load the provided memory card. ( pg. 16)			Insert Editing
Then, perform step 1 and 2 of “Audio Dubbing”
( pg. 56).
2 Press MENU. The Menu Screen appears.	You can record a new scene into a previously
	recorded tape, replacing a section of the original
3 Press + or – to select “s”, and press SET/
	recording with minimal picture distortion at the in
SELECT. The SYSTEM Menu appears.	and outpoints. The original audio remains
4 Press + or – to select “SOUND IN”, and press	unchanged.
SET/SELECT. The Sub Menu appears.
5 Press + or – to select “D.SOUND”, and press				START/STOP
SET/SELECT.				INSERT
6 Press + or – to select “BRETURN”, and press SET/			REW
				PLAY
SELECT twice. The Menu Screen closes and the
sound effect indication appears.			STOP	PAUSE
7 Press INDEX to access the sound effects Index
Screen.
8 Press + or – to select the desired sound effect and	NOTES:
press SET/SELECT.	● Before performing the following steps, make sure
9 Press PLAY (U) to begin Audio Dubbing. The
		that “TIME CODE” is set to “ON”. ( pg. 31, 41)
selected sound effect is dubbed onto the tape.	● Insert Editing is not possible on a tape recorded in
● The “ ” moves while it is being dubbed.		the LP mode or on a blank portion of a tape.
● To stop dubbing the sound effect midway, press	● To perform Insert Editing while watching in the
D.SOUND.		television, make connections. ( pg. 22)
10 Press STOP (8) to end Audio Dubbing.	1 Play back the tape, locate the Edit-Out point and
NOTES:			press PAUSE (9). Confirm the time code at this
			point. ( pg. 41)
● After dubbing, set “SOUND IN” back to “MIC/
	2 Press REW (3) until the Edit-In point is located,
AUX”.
● The dubbed sound effect is recorded on			then press PAUSE (9).
SOUND 2. ( pg. 40)	3 Press and hold INSERT (I) on the remote
● If you press PAUSE (9) to pause dubbing in step 9			control, then press PAUSE (9). The “9I”
the selected sound effect indication remains			indicator and the Time Code (min.:sec.) appear
displayed. To resume dubbing, press PLAY (U).			and the camcorder enters Insert-Pause mode.
	4 Press START/STOP to begin editing.
			● Confirm the insert at the time code you

checked in step 1.

● To pause editing, press START/STOP. Press it again to resume editing.

5 To end Insert Editing, press START/STOP, then STOP (8).

NOTES:

● Program AE with special effects ( pg. 33) can be used to spice up the scenes being edited during Insert Editing.

● During Insert Editing, the date and time information changes.

● If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

● During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting stops. ( pg. 80, 81)

● If a memory card is loaded and “NAVIGATION” is set to other than “MANUAL”, a NAVIGATION thumbnail image is stored in the memory card. ( pg. 47)

ADVANCED FEATURES