| EDITING EN 35 | |
Dubbing To Or From A Video Unit | NOTES: | |
● It is recommended to use the AC Adapter as the power | ||
Equipped With A DV Connector (Digital | supply instead of the battery pack. ( pg. 7) | |
| ||
Dubbing) | ● If the remote control is used when both the player and | |
recorder are JVC video units, both units will perform the | ||
| same operation. To prevent this from happening, press the | |
It is also possible to copy recorded scenes from the | buttons on both units. | |
camcorder onto another video unit equipped with a DV | ● If a blank portion or disturbed image is played back on the | |
connector. Since a digital signal is sent, there is little if | player during dubbing, the dubbing may stop so that an | |
any image or sound deterioration. | unusual image is not dubbed. | |
● Even though the DV cable is connected correctly, | ||
| ||
| sometimes the image may not appear in step 9. If this | |
| occurs, turn off the power and make connections again. | |
| ● If “Playback Zoom” ( pg. 16) or “Playback Special Effects” | |
| ( pg. 16) is attempted or SNAPSHOT is pressed during | |
| playback, only the original playback image recorded on the | |
| tape is output from the DV IN/OUT connector. | |
| ● When using a DV cable, be sure to use the optional | |
| JVC |
Core filter 
To DV IN/OUT
DV cable (optional)
To DV IN/OUT
Video unit equipped with DV connector
To use this camcorder as a recorder
1)Perform steps 1 to 4 in “To use this camcorder as a player”.
2)Set “REC MODE” to “SP” or “LP”. ( pg. 25, 26)
3)Insert the recording cassette in this camcorder.
4)Press the Recording Start/Stop Button to engage the
● The “ DV. IN ” indication appears on the screen.
5)Press the Recording Start/Stop Button to start recording. The T indication rotates.
6)Press the Recording Start/Stop Button again to stop recording. The T indication stops rotating.
NOTES:
●If no image is displayed on the LCD monitor, set “S/AV INPUT” to “OFF”. ( pg. 25, 28)
●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting. ( pg. 26)
ADVANCED FEATURES
To use this camcorder as a player
1 Make sure all units are turned off.
2 Connect this camcorder to a video unit equipped with a DV input connector using a DV cable as shown in the illustration.
3 Set this camcorder’s VIDEO/MEMORY Switch to “VIDEO”.
4 Set this camcorder’s Power Switch to “PLAY” while pressing down the Lock Button located on the switch.
5
6
7
8 Press 4/9 on this camcorder to start playback of the source cassette.
9 At the point you want to start dubbing, engage the video unit’s Record mode.
10 To pause dubbing, engage the video unit’s Record- Pause mode and press 4/9 on this camcorder.
11 Repeat steps 8 – 10 for additional editing. Stop the video unit and camcorder.
