GETTING STARTED EN 9
Viewfinder Adjustment
Brightness Adjustment Of The Display
1 Set the Power Switch to “A” or “M” while pressing down the Lock Button located on the switch.
2 Make sure the LCD monitor is closed and locked. Pull out the viewfinder fully and adjust it manually for best viewability.
3 Turn the Diopter Adjustment Control until the indications in the viewfinder are clearly focused.
1 Set the Power Switch to “M” or “PLAY” while pressing down the Lock Button located on the switch.
2 Open the LCD monitor fully. ( pg. 12)
3 Press the MMENU/VOL. Wheel in. The Menu Screen appears.
4 Rotate the MMENU/VOL. Wheel to select “n”, and press it. The CAMERA DISPLAY Menu appears.
MMENU/VOL.
BRIGHT
STARTED
PAUSE
Diopter Adjustment Control
CAUTION:
When retracting the viewfinder, take care not to pinch your fingers.
5 Rotate the MMENU/VOL.
Wheel to select “BRIGHT”, and press it. The Menu Screen closes and the brightness control indicator appears.
6 Rotate the MMENU/VOL. Wheel until the appropriate brightness is reached.
7 Press the MMENU/VOL. Wheel in.
●It is also possible to adjust the brightness of the viewfinder by pulling out the viewfinder, setting “PRIORITY” in the SYSTEM Menu to “FINDER” ( pg. 25, 27) and adjusting as described above.
Tripod Mounting
To attach the camcorder to a tripod, align the direction stud and screw to the mounting socket and stud hole on the camcorder. Then tighten the screw clockwise.
● Some tripods are not equipped with studs.
CAUTION:
When attaching the camcorder to a tripod, extend its legs to
stabilize the camcorder. It is not advised to use small sized tripods. This may cause damage to the unit by falling over.
GETTING
