Listening to FM and AM Broadcasts, Tuning in a Station

English

Listening to FM and AM Broadcasts

Tuning in a Station
1 Press FM/AM.
The unit automatically turns on and tunes in	FM /AM
the previously tuned station (either FM or
AM).
• Each time you press the button, the band	FM/AM
alternates between FM and AM.

2 Press and hold TUNING – or + for TUNING / VCD NUMBER

more than 1 second.	–	+
The unit starts searching for stations and
stops when a station of sufficient signal
strength is tuned in.

If a program is broadcast in stereo, the ST (stereo) indicator lights up.

To stop during searching, press TUNING – or +.

When you press TUNING – or + briefly and repeatedly

The frequency changes step by step.

When an FM stereo broadcast is hard to receive or

noisy, press FM MODE on the remote control so FM MODE that the MONO indicator lights up on the display. Reception improves.

To restore the stereo effect, press FM MODE again so that the MONO indicator goes off.

In this stereo mode, you can hear stereo sounds when a program is broadcast in stereo.

2 Press number button on the	1	2	3
remote control to select a
preset number.	4	5	6
For preset number 1 to 10, press
and hold the number button for the	7	8	9
preset number you want to set.
For preset number 10 to 20, press	10	+10
and hold 1 to 10 after pressing

+10.

For preset number 20 to 30, press and hold 1 to 10 after pressing +10 twice.

Release the button after the number starts flashing. This completes the preset setting.

The tuned station in step 1 is stored in the preset number selected in step 2.

•Storing a new station on a used number erases the previously stored one.

When you unplug the AC power cord or if a power failure occurs

The preset stations will be erased in a few days. If this happens, preset the stations again.

	Tuning in a Preset Station
	1 Press FM/AM.
	The unit automatically turns on and tunes in	FM /AM
	The unit automatically turns on and tunes in
	the previously tuned station (either FM or
	AM).
	• Each time you press the button, the band	FM/AM
	alternates between FM and AM.	FM/AM
	alternates between FM and AM.

	You can preset 30 FM and 15 AM stations.	2 Select a preset number.
	In some cases, test frequencies have been already memorized	2 Select a preset number.
	for the tuner since the factory examined the tuner preset	On the unit:
	function before shipment. This is not a malfunction. You can	Press PRESET – or +.
	preset the stations you want into memory by following the
	presetting method.	On the remote control:
	• There is a time limit in doing the following steps. If the	On the remote control:
		Press the number buttons.
	setting is canceled before you finish, start from step 1	Press the number buttons.
	setting is canceled before you finish, start from step 1	For preset number 5, press 5.
	again.	For preset number 5, press 5.
	again.	For preset number 15, press +10
	1 Tune in the station you want to preset.	For preset number 15, press +10
		then 5.
		For preset number 20, press +10,
	• See “Tuning in a Station” above.	For preset number 20, press +10,
	• See “Tuning in a Station” above.	then 10.
		then 10.
		For preset number 25, press +10,
	MHz	+10, then 5.