JVC MX-J270V manual Recording Tapes on Deck B, Press Eject 0for the deck B

Put in a recordable cassette, with the exposed part of the tape down.

Close the cassette holder gently.

English

Recording

IMPORTANT:

•It may be unlawful to record or play back copyrighted material without the consent of the copyrighted owner.

•The recording level is automatically set correctly, so it is not affected by the VOLUME control. Thus, during recording you can adjust the sound you are actually listening to without affecting the recording level.

•While recording, you can hear sound modes and/or the active bass extension effect through the speakers or headphones. However, the sound is recorded without these effects (see page 10).

•If recordings you have made have excessive noise or static, the unit may be too close to a TV. Increase the distance between the TV and the unit.

•You can use type I and II tapes for recording.

To protect your recording

Cassettes have two small tabs on the back to protect unexpected erasure or re-recording.

To protect your recording, remove these tabs.

To re-record on a protected tape, cover the holes with adhesive tape.

When using type II tape, be careful not to cover the holes used to detect the tape type.

Type II detection slot

Adhesive tape

Recording Tapes on Deck B

1 Press EJECT 0for the deck B.

0EJECT

0EJECT

2

3

4 Check the tape direction of deck B.

• When using the unit:

If the tape direction is not correct, press TAPE 2 3 twice then 7to change the tape direction.

• If you want to record on both sides of a tape, press

REVERSE MODE until the indicator is lit.

5 Start playing the source — FM, AM*, CD player, deck A, or auxiliary equipment connected to AUX jacks.

•When the source is CD, you can also use CD Direct Recording (see page 22).

•When the source is deck A, you can also use the dubbing method. (See “Dubbing Tapes” on page 22.)

* See “To record an AM station — Beat Cut” on page 22.

6 Start recording.

On the unit:

Press REC START/STOP.	REC
	START/STOP

The indicator lights up on the display and recording starts.

On the remote control:

1)Press REC PAUSE.

The indicator starts flashing on the display.

2)Press TAPE 2or TAPE 3.

The indicator stops flashing and remains lit, and recording starts.

REC PAUSE

TAPE

TAPE

To stop during recording, press REC START/STOP again, or press 7 on the unit (or TAPE 7on the remote control).

– 21 –