JVC MX-J270V manual Connecting Speakers, Release the finger from the clamp, AM antenna

English

AM antenna

1

2

Vinyl-covered wire (not supplied)

	ANTENNA
	FM
FM
75	GND
AM
EXT	GND
	AM LOOP

3

AM loop antenna (supplied)

1If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

2Connect the AM loop antenna to the AM LOOP terminals as illustrated.

3Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)

Connecting Speakers

You can connect a pair of the front speakers.

1
2	3			4
		Red
Speaker	CAUTION:		SPEAKERS	Speaker
	SPEAKER IMPEDANCE
cord	6~16 OHMS	RIGHT	LEFT	cord
		Black
Right				Left
speaker				speaker

1If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

2Press and hold the clamp of the speaker terminal on the rear of the unit.

3Insert the end of the speaker cord into the

terminal.

Match the polarity of the speaker terminals: Red (+) to red (+) and black (–) to black (–).

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

4Release the finger from the clamp.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 7 –