JVC MX-K35V manual Connecting the AM Antenna, Connecting the Speakers, Getting Started, English

English

Getting Started

Connecting the AM Antenna

Rear Panel of the Unit

		Turn the loop until you
		have the best reception.
AM EXTloopAMANTENNAantenna75FM		(Supplied)
LOAMOP	FM
GND	GND	Attach the AM loop to its
		base by snapping the
		tabs on the loop into the
		slot in the base.
	AM antenna wire (not supplied)
	If reception is poor, connect the outside antenna.

•Even when connecting an outside AM antenna, keep the indoor AM loop connected.

CAUTION:

•To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.

Connecting the Speakers

1.Open each of the terminals to connect the speaker wire leads.

2.Connect the speaker cords to the Speaker terminals of the Unit.

Connect the red (+) and black (–) wires of the right side speaker to the red (+) and black (–) terminals marked RIGHT on the System. Connect the red (+) and black (–) wires of the left side speaker to the red (+) and black (–) terminals marked LEFT on the System.

3.Close each of the terminals to securely connect the cords.

Right side (rear view)	Left side (rear view)
	CAUTION:

SPEAKER IMPEDANCE 616 OHMS.

Red	SPEAKERS
	RIGHT	LEFT	Red
Black			Black

CAUTIONS:

•A TV may display irregular colors if located near the speakers. If this happens, set the speakers away from the TV.

•Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.

5