JVC MX-KC45 Connecting the AM Antenna, Connecting the Speakers, English, Rear Panel of the Unit

Models: MX-KC45

1 62
Download 62 pages 42.15 Kb
Page 40
Image 40
Manual background

English

Getting Started

Connecting the AM Antenna

Rear Panel of the Unit

AM antenna wire (not supplied)

If reception is poor, connect the outside antenna.

Turn the loop until you

Manual background have the best reception.

AM loop antenna (Supplied)

Attach the AM loop to its base by snapping the tabs on the loop into the slot in the base.

• Even when connecting an outside AM antenna, keep the indoor AM loop connected.

Manual backgroundCAUTION:

• To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.

Connecting the Speakers

1.Open each of the terminals to connect the speaker wire leads.

2.Connect the speaker cords to the Speaker terminals of the Unit.

Connect the gray (+) and gray with black stripe (–) cords of the right side speaker to the red (+) and black (–) terminals marked RIGHT on the System.

Connect the gray (+) and gray with black stripe (–) cords of the left side speaker to the red (+) and black (–) terminals marked LEFT on the System.

3.Close each of the terminals.

Right side (rear view)

Left side (rear view)

GrayGray

Gray with black stripe

Gray with black stripe

Manual backgroundCAUTIONS:

A TV may display irregular colors if located near the speakers. If this happens, set the speakers away from the TV.

Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.

5

Page 40
Image 40
JVC MX-KC45 Connecting the AM Antenna, Connecting the Speakers, English, Rear Panel of the Unit, Getting Started, Cautions