JVC MX-KC45 Warnings, Cautions and Others, Note to CATV system installer, For U.S.A, Information

Models: MX-KC45

1 62
Download 62 pages 42.15 Kb
Page 2
Image 2
Warnings, Cautions and Others /

Warnings, Cautions and Others /

Mises en garde, précautions et indications diverses

(For U.S.A)

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK)

NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magni- tude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and mainte- nance (servicing) instructions in the literature accompanying the appliance.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

Changes or modifications not approved by JVC could void the user’s authority to operate the equipment.

INFORMATION

This equipment has been tested and found to com- ply with the limits for a Class B digital device, pursu- ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communica- tions. However, there is no guarantee that interfer- ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is con- nected.

Consult the dealer or an experienced radio/TV technician for help.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to section 820-40 of the NEC which provides guidelines for proper grounding and, in partic- ular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

For Canada/pour le Canada

THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE INTERFERENCE-CAUSING EQUIPMENT STANDARD ENTITLED “DIGITAL APPARATUS,” ICES-003 OF THE DEPARTMENT OF COMMUNICATIONS.

CET APPAREIL NUMERIQUE RESPECTE LES LIMITES DE BRUITS RADIOELECTRIQUES APPLICABLES AUX APPAREILS NUMERIQUES DE CLASSE B PRESCRITES DANS LA NORME SUR LE MATERIEL BROUILLEUR: “APPAREILS NUMERIQUES”, NMB-003 EDICTEE PAR LE MINISTRE DES COMMUNICATIONS.

CAUTION –– % STANDBY/ON button !

ATTENTION –– Touche % STANDBY/ON

Disconnect the mains plug to shut the power off completely

Déconnectez la fiche de secteur pour mettre l’appareil

(all lamps and indications go off). When installing the

complètement hors tension (tous les témoins et toutes les

product, ensure that the plug is easily accessible. The %

indications s’éteignent). Lors de l’installation de l’appareil,

STANDBY/ON button in any position does not disconnect

assurez-vous que la fiche soit facilement accessible. La

the mains line.

touche % STANDBY/ON dans n’importe quelle position ne

• When the unit is on standby, the STANDBY lamp lights red.

déconnec-te pas l’appareil du secteur.

• When the unit is turned on, the STANDBY lamp goes off.

• Quand l’appareil est en mode d’attente, le témoin

The power can be remote controlled.

STANDBY est al-lumé en rouge.

 

• Quand l’appareil est sous tension, le témoin STANDBY

 

s’éteint.

 

L’alimentation ne peut pas être commandée à distance.

 

 

G-1

Page 2
Image 2
JVC MX-KC45 manual Warnings, Cautions and Others, Note to CATV system installer, For U.S.A, Information