JVC RX-6022VSL manual Basic Operations, Adjusting the Volume

Changing the source name

When you connect the CD recorder to the TAPE/CDR jacks on the rear panel, change the source name shown on the display.

1Press TAPE/CDR (SOURCE NAME).

• Make sure “TAPE” appears on the display.

2Press and hold SOURCE NAME (TAPE/CDR) until “ASSIGN CDR” appears on the display.

Remote

NOT

TAPE/CDR

SOURCE NAME

Adjusting the Volume

On the front panel: MASTER VOLUME

To increase the volume, turn MASTER

VOLUME clockwise.

To decrease the volume, turn it

counterclockwise.

From the remote control:

To increase the volume, press VOLUME +.

To decrease the volume, press VOLUME –.

Basic Operations

To change the source name from “CDR” to “TAPE,” repeat the

same procedure above (in step 1, make sure “CDR” appears on the display).

Note:

Without changing the source name, you can still use the connected component. However, there may be some inconvenience:

–“TAPE” will appear on the display when you select the CD recorder.

–You cannot use the digital input (see page 11) for the CD recorder.

–You cannot use the COMPU LINK remote control system (see page 25) to operate the CD recorder.

Selecting different sources for each picture and sound

You can watch picture from a video component while listening to sound from another component.

Press one of the audio source selecting buttons—CD, TAPE/CDR, FM, AM (FM/AM), while viewing the picture from a video component such as the VCR or DVD player, etc.

			TAPE/CDR	CD	DVD	DVD MULTI
CD	TAPE/CDR	FM	AM	TV SOUND	VCR
			FM/AM

SOURCE NAME

On the front panel From the remote control

VOLUME

CAUTION:

Always set the volume to the minimum before starting any source. If the volume is set at its high level, the sudden blast of sound energy can permanently damage your hearing and/or ruin your speakers.

Note:

The volume level can be adjusted within the range from “0” (minimum) to “50” (maximum).

Listening Only with Headphones	Remote
	NOT

You must turn off speakers when you listen with headphones.

1Connect a pair of headphones to the PHONES jack on the front panel.

2Press SPEAKERS ON/OFF.

•“HEADPHONE” appears for a while and the H. PHONE indicator lights up on the display.

The H. PHONE indicator lights up.

ANALOG

L R H.PHONE

Note:

Once you have selected a video source, pictures of the selected source are sent to the TV until you select another video source.

This cancels the Surround mode currently selected, and activates the HEADPHONE mode (see below).

HEADPHONE mode:

When using the headphones, following signals are output regardless of your speaker setting:

—For 2 channel sources, the front left and right channel signals are output directly from the headphones.

—For multichannel sources, the front left, right, center, and rear channel signals are down-mixed and then output from the headphones.

You can enjoy multichannel sound sources using the headphones.

CAUTION:

Be sure to turn down the volume:

•Before connecting or putting on headphones, as high volume can damage both headphones and your hearing.

•Before turning on speakers again, as high volume may output from the speakers.

9