AV COMPU LINK Remote Control System
The AV COMPU LINK remote control system allows you to operate JVC’s audio components through the remote sensor on the receiver. To use this remote control system, you need to connect the video components you want to operate by following the diagram and the procedure below.
•Make sure that AC power cords of these components are unplugged before connecting. Plug AC power cords only after all connections are completed.
CONNECTIONS:
VCR
VHS |
AV
COMPU LINK
DVD player
DVD |
AV
COMPU LINK
AV |
COMPU LINK |
Note:
TV
AV COMPU LINK EX
AV
COMPU LINK III
You can only connect to the TV with the AV COMPU LINK EX or AV
COMPU LINK III terminal.
The TV with AV COMPU LINK RECEIVER/AMP terminal will not be used.
Notes:
•When connecting only the VCR and DVD player to this receiver, use the cable with monaural
•You can connect only the TV with AV COMPU LINK to the AV COMPU LINK terminal.
•Refer also to the manuals supplied with your video components.
•Make sure that the remote control code of the VCR connected to the VCR jacks is set to code “A.”
1Unplug your VCR, DVD player, TV, and this receiver from the AC outlets.
2Connect your VCR, DVD player, TV, and this receiver using cables with the monaural mini- plugs (not supplied).
•See “CONNECTIONS” above.
3Connect VCR, DVD player, TV, and this receiver using cables with RCA pin plug.
•See pages 6 and 7.
4Plug AC power cords of the components back into the AC outlets.
5When turning on the TV for the first time after the AV COMPU LINK connection, turn the TV volume to the minimum with the volume control on the TV.
6Turn on the other connected components first, then turn on this receiver.
•When turning on the VCR, use the remote control supplied
with this receiver (press STANDBY/ON VCR).
26