Getting Started
Before Installation
General Precautions
•DO NOT insert any metal object into the unit.
•DO NOT disassemble the unit or remove screws, covers, or cabinet.
•DO NOT expose the unit to rain or moisture.
Locations
•Install the unit in a location that is level and protected from moisture.
•The temperature around the unit must be between
•Make sure there is good ventilation around the unit. Poor ventilation could cause overheating and damage the unit.
Handling the unit
• DO NOT touch the power cord with wet hands. |
• DO NOT pull on the power cord to unplug the cord. When |
unplugging the cord, always grasp the plug so as not to |
damage the cord. |
• Keep the power cord away from the connecting cords and |
the antenna. The power cord may cause noise or screen |
interference. Coaxial cable is recommended for the antenna |
connection, since such cable is |
interference. |
Rear panel
•If FM reception is poor, connect an outdoor FM antenna.
75 FMAXIAL CO
75 FMCOAXIAL
Standard type outdoor FM antenna (not supplied)
| FM antenna (supplied) | |
ANTENNA | ||
|
FM 75
COAXIAL
Extend the supplied FM antenna horizontally.
Parts Identification/Getting Started
• When a power failure occurs, or when you unplug the power |
cord, the preset settings such as preset FM or AM channels |
and sound adjustments may be erased within a few days. |
Checking the Supplied Accessories
Check to be sure you have all of the following supplied accessories. The number in parentheses indicates the quantity of each piece supplied.
• Remote control (1) |
• Batteries (2) |
• AM loop antenna (1) |
AM
LOOP
AM loop antenna (supplied)
AM
EXT
If AM reception is poor, connect outdoor single
Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna.
• FM antenna (1) |
If anything is missing, contact your dealer immediately.
Connecting the AM and FM Antennas
AM antenna connection
Connect the supplied AM loop antenna to the AM LOOP terminals.
Turn the loop until you have the best reception.
•If the reception is poor, connect an outdoor single vinyl- covered wire (not supplied) to the AM EXT terminal. (Keep the AM loop antenna connected.)
FM antenna connection
Connect the supplied FM antenna to the FM 75 Ω COAXIAL terminal as a temporary measure.
Extend the supplied FM antenna horizontally.
•If the reception is poor, connect an outdoor FM antenna (not supplied). Before attaching a 75 Ω antenna with a coaxial type connector, disconnect the supplied FM antenna.
7How to connect the AM antenna cord
123
1Open the terminal.
2Insert the AM antenna cord.
3Close the terminal.
Notes:
•If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown to the right.
•Make sure the antenna conductors do not touch any other terminals, connecting cords, or power cord. This could cause poor reception.
5