JVC RX-5032VSL, RX-6032VSL, RX-6030VBK manual Getting Started

English

Getting Started

Connecting the Speakers and Subwoofer	7 Speaker layout diagram
You can connect five speakers—a pair of front speakers, a
center speaker, and a pair of surround speakers—and a
subwoofer.	Center
	speaker
CAUTION:	Left front	Right front
Use speakers with a SPEAKER IMPEDANCE as indicated by the	speaker	Subwoofer speaker

speaker terminals.

Left	Right
surround	surround
speaker	speaker

7Connection diagram

								:
							CAUTION	IMPEDANCE
							SPEAKER16
						FRONT	8
						SPEAKERS	+
			SURROUND		+		–	To left
				+
			SPEAKERS
			CENTER		–			front speaker
			SPEAKER	–
			+
			–					To left surround
								speaker
	To subwoofer	To center speaker
SUBWOOFER
	input	To right front speaker
OUT
		To right	surround speaker
		Powered
		subwoofer

7How to connect speaker cords

For each speaker, connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers.

1 2 3

1

2

+	+
–	–

1Twist and remove the insulation at the end of each speaker cord.

2Open the terminal (1), then insert the speaker cord (2).

3Close the terminal.

7How to connect the subwoofer

Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs (not supplied).

•Refer also to the manual supplied with your subwoofer.

By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in the digital software.

Since bass sound is non-directional, you can place a subwoofer wherever you like. Normally place it in front of you.

After connecting the front, center, surround speakers and/ or a subwoofer, set the speaker setting information properly to obtain the best possible Surround effects with your listening conditions. For details, see pages 15 and 16.

•“NO” for the subwoofer, “LARGE” for the front speakers, and “SMALL” for the center and surround speakers are initial settings.

6