Selecting the Analog or Digital Input
Mode
When you have connected digital source components using both the analog connection (see page 6) and the digital connection (see page 9) methods, you need to select the input mode correctly.
Before you start, remember....
There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
1Press one of the source selecting
DVD MULTI | DVD | VCR | TV SOUND/DBS | DVD | DVD MULTI | CD | FM/AM |
|
|
|
| ||||
|
|
| SOURCE NAME | TV/DBS | VCR | TAPE/CDR | PHONO |
|
|
|
| ||||
CD | TAPE/CDR | PHONO | FM/AM |
|
|
|
|
SOURCE NAME
On the front panel | From the remote control |
Note:
*Among the sources listed above, you can select the digital input only for the sources which you have selected the digital input terminals for. (See “Setting the Digital Input (DIGITAL IN) Terminals” on page 14.)
2Press INPUT ANALOG/DIGITAL
(or ANALOG/DIGITAL INPUT on the remote control) to select the digital input mode.
INPUT |
|
ANALOG / DIGITAL | ANALOG/DIGITAL |
| INPUT |
INPUT ATT |
|
On the front panel | From the remote control |
•Each time you press the button, the input mode alternates between the analog input (“ANALOG”) and the digital input (“DIGITAL AUTO”).
DIGITAL AUTO : Select this for the digital input mode. The receiver automatically detects the incoming signal format. (The DIGITAL AUTO indicator lights up on the display, then the digital signal indicator for the detected signals lights up.)
ANALOG : Select this for the analog input mode. (Initial setting when shipped from the factory.)
If the following symptoms occur while playing Dolby Digital or DTS Digital Surround software with “DIGITAL AUTO” selected, follow the procedure below:
•Sound does not come out at the beginning of playback.
•Noise comes out while searching or skipping chapters or tracks.
1Press INPUT ANALOG/DIGITAL (or ANALOG/ DIGITAL INPUT on the remote control.)
INPUT
ANALOG / DIGITAL | ANALOG/DIGITAL |
| INPUT |
INPUT ATT |
|
On the front panel | From the remote control |
2 Press CONTROL UP 5/DOWN ∞ to | Remote | |
select “DOLBY DIGITAL” or “DTS | ||
NOT | ||
SURROUND” while “DIGITAL | ||
| ||
AUTO” still remains on the display. |
|
•Each time you press the button, the digital input mode changes as follows:
When “DOLBY DIGITAL” or “DTS SURROUND” is selected, “DIGITAL AUTO” goes off.
SPK
DIGITAL AUTO L C R
S.WFR LFE
DIGITAL LS S RS
CH-
DIGITAL AUTO 
DTS SURROUND 
DOLBY DIGITAL 
•To play back software encoded with Dolby Digital, select “DOLBY DIGITAL.”
•To play back software encoded with DTS Digital Surround, select “DTS SURROUND.”
Note:
When you turn off the power or select another source, “DOLBY DIGITAL” and “DTS SURROUND” are canceled and the digital input mode is automatically reset to “DIGITAL AUTO.”
The followings are the analog/digital signal indicators on the display to indicate what type of the signal comes into the receiver.
ANALOG : Lights when the analog input is selected.
LINEAR PCM : Lights when Linear PCM signals come in. 
DIGITAL : • Lights when Dolby Digital signals come in.
•Flashes when “DOLBY DIGITAL” is selected for software not encoded with Dolby
Digital signals.
: • Lights when DTS signals come in.
•Flashes when “DTS SURROUND” is selected for software not encoded with DTS signals.
Note:
When “DIGITAL AUTO” cannot recognize the incoming signals, no
digital signal indicators light up on the display.
Basic Settings
15
