On the front panel ONLY:
1. Press SETTING repeatedly until
“DIGITAL IN” appears on the display.
SETTING
2. Press ANALOG/DIGITAL to | ANALOG/DIGITAL |
change the input mode. |
|
•Each time you press the button, the input mode alternates between the digital input and analog input.
English
The display changes to show the current setting.
DIGITAL 2 terminal setting
VOLUME
DIGITAL 1 terminal setting
MULTI JOG
2.Turn MULTI JOG to select the appropriate digital terminal setting.
• As you turn it, the display changes to show the following:
1 DVD 2 CD Ò | 1 DVD 2 MD Ò | 1 DVD 2 DBS Ò |
1 CD 2 MD Ò | 1 CD 2 DBS Ò | 1 MD 2 DBS Ò |
(back to the beginning) |
| |
|
|
|
Note:
When shipped from the factory, the DIGITAL IN terminals can be used as the digital input for the following components.
•DIGITAL 1: For DVD player
•DIGITAL 2: For CD player
Selecting the Analog or Digital Input
Mode
When you have connected some components such as CD player, MD recorder, DVD player and the DBS tuner using digital terminals (see page 8), you need to change the input mode for these components to the digital input.
On the front panel:
1. Turn SOURCE SELECTOR until | SOURCE SELECTOR |
the source (CD, MD, DBS, or |
|
DVD) for which you want to |
|
change the input mode from |
|
analog input to digital input |
|
appears on the display. |
|
2. Press INPUT ANALOG/DIGITAL | INPUT |
to change the input mode. | ANALOG/DIGITAL |
|
•Each time you press the button, the input mode alternates between the digital input and analog input.
Notes:
*Before pressing TV/DBS, make sure that the remote control mode selector on the remote control is set to “CATV/DBS.”
•Once you have set the digital input for these components, it is always used every time you select these components as the source.
IMPORTANT:
The sampling rate converter built in this unit corresponds only to
32 kHz, 44.1 kHz, and 48 kHz. If the signals of a different sampling frequency come into this unit, noise may occur.
Showing the Text Information on the
Display
When you have connected an MD recorder or CD player equipped with TEXT COMPU LINK remote control system (see page 34), you can show the text information, such as disc title or track (song) title, on the display of this receiver.
To show it on the display, follow the procedure below.
Before you start, remember...
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press SETTING repeatedly until | SETTING |
| |
“FL DISPLAY” appears on the |
|
display. |
|
The display changes to show the current setting.
2. Turn MULTI JOG to select either | MULTI JOG |
| |
the source name or the text |
|
information to be shown on the |
|
display. |
|
• As you turn it, the display changes to show the following:
NORMAL
TEXT
NORMAL: Source name appears during play.
TEXT: Text information appears during play.
Notes:
From the remote control:
1.Press the source selecting button (CD, TAPE/MD, TV/ DBS*, or DVD) for which you want to change the input mode from analog input to digital input.
DVD | CD | TAPE/MD |
TV/DBS | PHONO | FM/AM |
VCR |
|
|
•Though you have selected “TEXT,” the source name such as “CD” or “MD” appears if a playing disc has no text information.
•Though you have selected “NORMAL,” the setting is changed to “TEXT” in the following case:
–If the power failure occurs.
–If you unplug the AC power cord.
13
