English
Digital connections
This receiver is equipped with two digital input terminals. You can connect any component to the digital terminals using digital optical cables (not supplied).
IMPORTANT:
•When connecting the DVD player or the DBS tuner using the digital terminal, you also need to connect it to the video jack on the rear. Without connecting it to the video jack, you can view no playback picture.
•After connecting the components using the DIGITAL IN terminals, set the following correctly if necessary.
–Select the digital input mode correctly. For details, see “Selecting the Analog or Digital Input Mode” on page 13.
–Set the digital input (DIGITAL IN) terminal setting correctly. For details, see “Digital Input (DIGITAL IN) Terminal Setting” on page 13.
Connecting the Power Cord
Before plugging the receiver into an AC outlet, make sure that all connections have been made.
Plug the power cord into an AC outlet.
Keep the power cord away from the connecting cables and the antenna. The
power cord may cause noise or screen interference. We recommend that you use a coaxial cable to connect the antenna, since it is well- shielded against interference.
Note:
The preset settings such as preset channel and sound adjustment may be erased in a few days in the following cases:
–When you unplug the power cord.
–When a power failure occurs.
|
| CAUTION: |
DBS tuner | DVD player | • Do not touch the power cord with wet hands. |
|
| • Do not pull on the power cord to unplug the cord. When |
|
| unplugging the cord, always grasp the plug so as not to damage |
DBS | DVD | the cord. |
CD player | MD recorder |
Putting Batteries in the Remote Control
When the component has a digital optical output terminal, connect it to the DIGITAL 1 (DVD) or DIGITAL 2 (CD) terminal, using the digital optical cable (not supplied).
Before connecting a digital optical cable, unplug the protective plug. 
DIGITAL IN
PCM/DOLBY DIGITAL
DIGITAL 1 (DVD)
DIGITAL 2 (CD)
Before using the remote control, put two supplied batteries first. When using the remote control, aim the remote control directly at the remote sensor on the receiver.
1 | 2 | 3 |
1.On the back of the remote control, remove the battery cover.
2.Insert batteries. Make sure to match the polarity:
(+) to (+).
Notes:
•When shipped from the factory, the DIGITAL IN terminals have been set for use with the following components.
–DIGITAL 1: For DVD player
–DIGITAL 2: For CD player
•When you want to operate the CD player or MD recorder using the COMPU LINK remote control system, connect the target component also as described in “Analog connections” (see page 6).
•When you want to operate the DVD player using the AV COMPU LINK remote control system, connect the DVD player also as described in “Analog connections” (see page 7).
3. Replace the cover.
If the range or effectiveness of the remote control decreases, replace the batteries. Use two
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
•Place batteries in the remote control so they match the polarity:
(+) to (+).
•Use the correct type of batteries. Batteries that look similar may differ in voltage.
•Always replace both batteries at the same time.
•Do not expose batteries to heat or flame.
8
