3Press the numeric buttons (0 – 9, h10) to select a channel number while the channel number position is flashing.
•For channel number 5, press 5.
•For channel number 10, press h10, 1, then 0.
•For channel number 25, press h10, 2, then 5.
4Press MEMORY again while the selected channel number is flashing on the
display.
The selected channel number stops flashing. The channel number is assigned to the station.
5Repeat steps 1 to 4 until you store all the stations you want.
To erase a stored preset station:
Storing a new station on a used channel number erases the previously stored one.
On the front panel:
2 1, 3
Before you start, remember...
There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.
1Turn SOURCE SELECTOR to select “FM” or
“AM.”
The last received station of the selected band is tuned in.
2Press TUNER PRESET.
“P” appears on the display, and MULTI JOG now works for selecting preset channels.
3Turn MULTI JOG to select a preset channel number.
•To increase the preset channel numbers, turn MULTI JOG clockwise.
•To decrease the preset channel numbers, turn MULTI JOG counterclockwise.
7 To tune in a preset station
From the remote control:
1Press FM/AM to select the band.
The last received station of the selected band is tuned in and the numeric buttons now work for selecting preset channels.
•Each time you press FM/AM, the band alternate between “FM” and “AM.”
2Press the numeric buttons (0 – 9, h10) to select a preset channel number.
•For channel number 5, press 5.
•For channel number 10, press h10, 1, then 0.
•For channel number 25, press h10, 2, then 5.
Selecting the FM reception mode
When an FM stereo broadcast is hard to receive or noisy, you can change the FM reception mode.
•You can store the FM reception mode for each preset station (see page 24).
From the remote control ONLY:
While listening to an FM station, press FM MODE.
•Each time you press the button, the FM reception mode alternates between “AUTO MUTING” and “MONO.”
AUTO MUTING | Normally select this. |
| When a program is broadcast in stereo, you |
| will hear stereo sound; when in monaural, |
| you will hear monaural sound. This mode is |
| also useful to suppress static noise between |
| stations. The AUTO MUTING indicator lights |
| up on the display. |
|
|
MONO | Select this to improve the reception (but |
| stereo effect will be lost). |
| In this mode, you will hear noise while |
| tuning in to the stations. The AUTO MUTING |
| indicator goes off from the display. (The |
| STEREO indicator also goes off.) |
|
|
Initial setting: | AUTO MUTING |
25
