JVC RX-E100RSL manual Using Surround Modes Remote Control, If Auto SR Auto Surround is set to on

It will be convenient for you to use the remote control for DSP operations, since you can adjust them from your listening point, and use the test signal.

•When using the buttons on the front panel, see pages 37 to 39.

		AUDIO
DVD	STB	VCR	TV
		SLEEP	TV DIRECT
DVD	STB	VCR	TV
ANALOG/DIGITAL	TAPE	FM	AM
INPUT
SOUND	BASS+	CENTER
	1	2	3
TEST	BASS–	REAR-L
TEST	4	5	6
BASS BOOST	TREBLE+	REAR-R
	7	8	9
EFFECT	TREBLE–	SUBWOOFER
	10	0	+10
	RETURN	FM MODE	100+

	EON SELECT
DISPLAY MODE		RDS
		DVD
DVD MENU	EON	MENU
PTY(		PTY9
	ENTER
DSP		SURROUND	SURROUND
MODE		ON/OFF
		PTY SEARCH	ON/OFF

TV VOL	CHANNEL		VOLUME
TV/VIDEO	DIMMER	VCR	MUTING
	CONTROL
/REW	PLAY		FF/
DOWN	TUNING		UP

REC STOPPAUSE

RM-SRXE100R REMOTE CONTROL

HOME CINEMA CONTROL CENTER

Using Surround Modes (Remote Control)

Surround mode cannot be used with another DSP mode. Once Surround mode is activated, the other DSP mode in use will be canceled.

• You have to make this adjustment for each source.

1Select and play software encoded with Dolby Surround, Dolby Digital, or DTS Digital Surround.

If “AUTO SR (Auto Surround)” is set to “ON”

Playing a digital source automatically activates an appropriate Surround mode. (See pages 18 and 19.)

2Press SURROUND ON/OFF to activate an appropriate Surround mode — Pro Logic, Dolby Digital, or DTS Digital Surround.

•Each time you press the button, Surround mode turns on and off alternately.

SURROUND

ON/OFF

AUTO

VOL

Then

AUTO

VOL

Ex.: When Dolby Digital is activated

Note:

When playing back an analogue source, “SURROUND ON” will not appear, and “PRO LOGIC” appears as soon as you press SURROUND ON/OFF. (The PRO LOGIC indicator also lights up on the display.)

3Press TEST to check the speaker output balance.

TEST

O LOGIC

P

TL AUTO

UT ATT VOL

“TEST L” starts flashing on the display, and a test tone comes out of the speakers in the following order:

(Left front speaker) (Center speaker) (Right front speaker)

Creating Realistic Sound Fields

Before you start, remember...

•Make sure that you have set the speaker information correctly (see page 15).

•You cannot adjust the center speaker output level when you have set “CTR SP” to “NO.”

•You cannot adjust the rear speaker output levels when you have set “REAR SP” to “NO.”

•Remember not to change the speaker setting while using any DSP mode; otherwise, it may be canceled when you deactivate the speakers required for the DSP mode.

(Left rear speaker) (Right rear speaker)

Notes:

•You can adjust the speaker output levels without outputting the test tone.

•No test tone comes out of the center speaker when “CTR SP” is set to “NO.”

•No test tone comes out of the rear speakers when “REAR SP” is set to “NO.”

TO BE CONTINUED ON THE NEXT PAGE

33