AM (MW/LW) antenna connection
Connect the AM (MW/LW) loop antenna supplied to the AM LOOP terminals.
Turn the loop until you have the best reception.
•If reception is poor, connect an outdoor single
Connecting the Speakers
After connecting the front, center, rear speakers and/or a subwoofer, set the speaker setting information properly to obtain the best possible DSP effect. For details, see page 15.
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
Getting Started
FM antenna connection
Connect the FM antenna supplied to the FM 75 Ω COAXIAL terminal as temporary measure.
Extend the supplied FM antenna horizontally.
•If reception is poor, connect an outdoor antenna. Before attaching a 75 Ω coaxial cable (with a standard type
connector), disconnect the supplied FM antenna.
Notes:
• If the AM (MW/LW) loop antenna wire is covered with vinyl, remove the vinyl while twisting it as shown to the right.
• Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.
Connecting the front, center, and rear speakers
1 | 2 | 3 |
|
|
|
For each speaker, connect the (+) and
1Cut, twist and remove the insulation at the end of each speaker cord (not supplied).
2Open the terminal, then insert the speaker cord.
3Close the terminal.
Connecting the subwoofer speaker
By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in the digital software.
Powered subwoofer |
|
(example) |
|
INPUT |
|
| SUBWOOFER |
HIGH IMPEDANCE | OUT |
|
Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs (not supplied).
•Refer also to the manual supplied for your subwoofer.
Since bass sound is
5
