Connections (continued)
Do not turn on the power until you complete the connection.
Connecting other equipment
Remote control mode selector
7
2/3(cursor)/
ENTER
| SCAN MODE | |
BASS | S. WFR OUT | |
ADJUST | ||
|
Connecting other speakers
To connect speakers other than the ones supplied, follow the operations shown below.
1 Slide the remote control mode selector to
RECEIVER.
2 Connect the speakers to the SPEAKERS WOOFER LEFT and RIGHT terminals on the receiver.
3 Hold down BASS ADJUST for 2 or more seconds.
•“Single Amp” is displayed in the display window on the receiver, and no audio signal is sent to the SPEAKERS TWEETER LEFT and RIGHT terminals.
Display on the receiverConnecting the subwoofer
When you connect this system with an amplifier-
Audio cord (not supplied)
(If an audio cord comes with the
Receiver
(rear panel)
NOTE
•The impedance of speakers connected to this system must be within the range 6 C to 16 C.
•When connecting the supplied speakers to the receiver, hold down BASS ADJUST on the remote control for 2 or more seconds once again to select
To produce sound from the subwoofer, press S.WFR OUT on the remote control to display “S. WOOFER ON” (Subwoofer on) in the display window on the receiver. Each time you press S.WFR OUT, the display toggles between
“S. WOOFER ON” and “S. WOOFER OFF”.NOTE
•When “S. WOOFER ON” is selected, bass sound from the left and right speakers will be automatically turned down and the bass sound will be emitted mainly from the subwoofer.
11