Operating the TV using the remote control
You can operate your TV using the remote control of this system.
| Remote control |
| mode selector |
| FTV |
| TV/VIDEO |
TV | TV |
CHANNEL | VOLUME |
ENTER
Number buttons
Setting the manufacturer code
1 Slide the remote control
mode selector to TV.
2 Hold down FTV.
• Hold down FTV until you finish step 4.3 Press ENTER and release.
4 Press number buttons (1-9, 0).
•Refer to “Using the number buttons” (A page 15).Examples:For a Hitachi TV: Press 1, then 0.For a Toshiba TV: Press 0, then 8.When the manufacturer of your TV has two or more codes, select the manufacturer codes in turn and find the one that operates the TV and the remote control properly.
Manufacturer | Code | Manufacturer | Code | Introduction |
| ||||
|
|
|
|
|
JVC | 01 | Samsung | 12 |
|
|
|
|
|
|
Hitachi | 10 | Sanyo | 13 |
|
|
|
|
|
|
Magnavox | 02 | Sharp | 06 |
|
|
|
|
|
|
Mitsubishi | 03 | Sony | 07 |
|
|
|
|
|
|
Panasonic | 04, 11 | Toshiba | 08 |
|
|
|
|
|
|
Philips | 14 | Zenith | 09 |
|
|
|
|
|
|
RCA | 05 |
|
|
|
|
|
|
|
|
NOTE
•A manufacturer code is subject to change without notice. You may not be able to operate the TV produced by the manufacturer.
5 Release FTV.
Using the remote control for the TV operationOperate the remote control by pointing it at the TV.Turns on/off the TV.Changes the channels.Adjusts the volume.~ | / | Selects the channels. |
/ 
NOTE
•After replacing the batteries of the remote control, set the manufacturer code again.
•When the remote control mode selector is slid to TV, some buttons may not work.
6