Listening to the sound of other audio equipment

Remote control mode selector

AUX3 (play)

MEMORY

Connect the other audio equipment to this system in advance (A page 12).

1 Slide the remote control mode selector to

RECEIVER.

2 Press AUX to select “AUX-DIGITAL” or “AUX”.

•Each time you press AUX, the display on the receiver toggles between “AUX-DIGITAL” and “AUX”.

•The source changes to the signal from the AUX terminals.

•You can also use SOURCE SELECT on the receiver to select the signal from the AUX terminals as the sound source.

3 Begin playback on the other audio equipment.

•For details on beginning playback, refer to the manual of the connected equipment.

4 Adjust the volume and the sound quality of the system (A page 16).

NOTE

•When no equipment is connected to the DIGITAL IN AUX terminal or the power of the connected equipment is off, after “AUX-DIGITAL” is selected, the display changes to “AUX-D UNLOCK”.

Adjust the sound input level of the audio equipment

You can adjust the sound input level of audio equipment connected to the AUX terminals.

1 Slide the remote control mode selector to

RECEIVER.

2 Press AUX to select “AUX”.

•Each time you press AUX, the display on the receiver toggles between “AUX-DIGITAL” and “AUX”.

•The source changes to the signal from the AUX terminals.

3 Hold down MEMORY until the input level is displayed.•Each time you hold down the button, the input level switches as follows:LEVEL1 STORED: For normal use. (initial setting)

LEVEL2 STORED: To correct distorted sound caused by an extremely high input level from other equipment.

41