SYSTEM CONNECTIONS EN 57

 

 

 

 

 

 

 

Connecting To A Dolby Digital Decoder

1 Connect the unit and a Dolby Digital decoder or an amplifier

 

 

 

 

with built-in DTS using either an optional optical cable or an

 

 

Or An Amplifier With Built-in DTS

optional coaxial cable.

 

 

NOTES:

 

 

 

● For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY

These instructions enable you to connect your unit to a Dolby

DIGITAL/PCM”. ( pg. 58)

Digital decoder or an amplifier with built-in DTS.

● For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”.

 

 

 

 

 

 

( pg. 58)

 

 

 

CAUTIONS:

Dolby Digital Decoder or

 

amplifier with built-in DTS

 

To DIGITAL AUDIO input

 

Optical cable

Coaxial cable

(not supplied)

(not supplied)

To [DIGITAL AUDIO OUT (OPTICAL)]

To [DIGITAL AUDIO

 

OUT (COAXIAL)]

●This unit has a dynamic range of more than 110 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

●Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the playback picture.

Rear of unit

Note for connection:

Remove the protection cap from the cable.