JVC SR-V10U 38 EN, OTHER USEFUL FUNCTIONS cont, Video Calibration, Picture Control, Auto Timer

38 EN		OTHER USEFUL FUNCTIONS (cont.)
		* The default setting is bold in the table below.
⬛ VIDEO CALIBRATION		When this function is set to “ON”, this VCR checks the condition of the
ON		tape in use during playback and recording, and compensates to provide
		the highest-possible pictures. This takes place whenever you play back a
OFF
		tape or start recording after inserting a tape.
		NOTES:
		● During playback, this function is always working even though “VIDEO
		CALIBRATION” appears just at the beginning of automatic tracking.
		● During recording, this function works only for the first EP recording and the first
		SP recording on an inserted tape.
		For timer recording, this function checks the tape condition both for the SP
		recording and the EP recording before the first timer recording starts.
		● When you play back rental tapes or tapes recorded on other VCRs, set this
		function either “ON” or “OFF” whichever gives you the best picture.
⬛ PICTURE CONTROL		This function helps you to adjust the playback picture quality according
AUTO (NORM): Normally select		to your preference.
	this. Picture quality is	NOTES:
	adjusted automatically.
	When “VIDEO	● When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not
	CALIBRATION” is “OFF”,	change until you select again.
		● Select "EDIT" when you are editing tapes (☞ pg. 45, 46, and 49). After you
	“NORM” will appear instead
		finish editing the tapes, select “AUTO” (“NORM” when “VIDEO
	of “AUTO”.
		CALIBRATION” is “OFF”.)
EDIT:	Minimizes picture
	degradation during editing
	(recording and playback).
SOFT:	Reduces image
	coarseness when viewing
	overplayed tapes
	containing much noise.
SHARP: Clearer, sharper-edged
	picture when viewing
	images with much flat,
	same-colored surfaces
	such as cartoons.
⬛ AUTO TIMER		● When this function is set to “ON”:
ON		The timer recording standby mode is automatically engaged when the
		VCR is turned off. It is temporarily canceled when the VCR is turned
OFF
		on. You do not have to press TIMER to engage or disengage the timer
		recording standby mode.
		● When this function is set to “OFF”:
		You have to press TIMER to engage or disengage the timer recording
		standby mode.
⬛ ON SCREEN (REC)		When this function is set to “ON”, all the indications displayed on
ON		screen will be recorded. If you do not want to record the indications,
OFF		select “OFF”. (☞ pg. 21)
		NOTE:
		● The setting you have made is kept in memory. Even if the VCR is unplugged or
		the power failure occurs, it will resume every time you turn on the VCR. (☞ pg.
		9)

Refer to page 37 for setting procedures.