JVC SR-V10U manual 36 EN, Confirm overlapping programs, Select program to modify

36 EN TIMER RECORDING (cont.)

3 Cancel or change program setting

1	2	3
		2
4	5	6
7	8	9
C –3	0	4

To cancel a program, press CANCEL when the Program screen you do not want is shown.

“PROGRAM COMPLETED” appears on the screen for about

5Ê seconds, then normal screen appears.

PROGRAM 4

START	STOP
9:00 PM	= 10:00PM
DATE	CH
12/24/00	10 SP

SUN

PRESS (CANCEL) TO CANCEL PRESS (OK) TO CONFIRM PRESS (PROG.) TO END

	C –3
1	C –3

C –3

C –2

C –2

C Whenother programs overlap each

If “PROGRAM NOT COMPLETED PROGRAM OVERLAP” appears, you have another program overlapping the program you have just made.

The Program Check screen appears and conflicting programs will start blinking.

	PR START		STOP	CH	DATE
PROGRAM NOT COMPLETED	1	8:00P	11:00	12	12/24
	2	10:00A	10:45	40	12/25
PROGRAM OVERLAP	3	11:30P	1:00	125	12/25
	4	9:00P	10:00	10	12/24
	5

6

7

8

(5,°), THEN ( 3) (PROG.) : END

EX. Program 1 (you have just made) and Program 4

overlap each other

1 Confirm overlapping programs

Overlapping programs blink on the screen.

2 Select program to modify

Press SHUTTLE PLUS %Þ, then press SHUTTLE PLUS #.

•You can only select one of the overlapping programs.

NOTE:

If you do not mind this overlap, press PROG. to finish the timer program setting. See “ATTENTION” to the right. Without doing anything for about 1 minute, the VCR will finish the timer programing.

To change a program, press the appropriate button: START+/–, STOP+/–, DATE+/–, CH+/–, and/or SP/ EP when the Program screen on which you want to make changes is shown, then press OK.

“PROGRAM COMPLETED” appears on the screen for about 5 seconds, then normal screen appears.

NOTE:

If the overlap is not yet solved or another overlap occurs with the timer program setting made last after making correction on a program, the conflicting programs will be shown on the Program Check screen again. Repeat the above steps again until the overlap is solved.

ATTENTION

If there is a conflict in the timer schedule and one program overlaps with another, only the parts shown below in gray will be recorded.

Pattern 1: The program with the lower program number will be recorded.

10:00	11:00	12:00
Program 1	CH10
Program 2			Not recorded
	CH40

Pattern 2:	The program starting earlier will be
	recorded.
	10:00	11:00	12:00
Program 1		CH10
	Program 2			Not recorded
		CH40

Pattern 3: The program starting earlier will be recorded, followed by the remaining portion of the other program.

10:00	11:00	12:00
Program 1	CH10
	Program 2
			CH40

Not recorded