JVC SR-V10U 24HR Quick Programing, 34 EN, 2Access 24HR quick program display, Set channel number

–WARNING–

TIMER RECORDING

TO START SOON (CANCEL)

34 EN TIMER RECORDING (cont.)

24HR Quick Programing

You can program a timer recording that starts within 24Ê hours. Up to 8Ê timer recording programs can be made as far as a year in advance. Remember, the clock must be set before you can program the timer (☞Ê pg.Ê 8 orÊ 10).

1 Load a cassette

POWER

REC LINK

S VIDEO	VIDEO (MONO)L—AUDIO—R
	DIGITAL TBC/NR	SP	EP
			VCR

JOG dial
REW	FF
PLAY
–	+
	CH– /+
	PUSH / TURN

A.DUB

24HR QUICK

PROGRAM

INSERT REC PAUSE STOP/EJECT

Make sure the record safety tab is intact. If not, cover the hole with adhesive tape, then load it into the VCR.

●The VCR turns on, and the counter is reset, automatically.

2Access 24HR quick program display.

Push 24HR QUICK PROGRAM. “ ” and start time start blinking on the display panel.

Program start time indicator

24HR QUICK PROGRAM

NOTES:

●If “Err” appears on the display panel, repeat the steps again.

●When a menu screen is shown, you cannot use 24HR quick programing function. Press MENU to return to normal screen, and try again.

●You can use 24HR quick programing function also when the VCR is turned off.

●For 24HR quick programing function, the program overlap warning display does not appear even if some programs overlap each other.

●In case of a power failure after programming, the recorder's memory backup keeps your selections (if the lithium battery is not exhausted).

3Set program start time

Turn the JOG dial to the left or right. Then, push the JOG dial. “” and start time start blinking on

the display panel.

Program start time indicator

●One click stop of the JOG dial changes the time in 5-minute intervals.

4 Set program stop time

Turn the JOG dial to the left or right. Then, push the JOG dial and channel number will start

blinking.

Program stop time indicator

●One click stop of the JOG dial changes the time in 5-minute intervals.

Timer warning display

A warning appears on the TV screen to tell you that the timer-recording is to start in 5Ê minutes if you are not in the timer recording standby mode at that time. Press TIMER to put the VCR into timer

recording standby mode. To clear the display, press CANCEL on the Remote.

5 Set channel number

Turn the JOG dial to the left or right.

●You can cancel the setting at any time by pressing and holding the JOG dial for more than 3 seconds. Repeat from the step 3.

6Engage timer recording standby mode

Press 24HR QUICK PROGRAM.

The VCR turns off automatically and “ä” is displayed on the front display panel.