JVC VN-C215V4U manual  Connection, Remove the inner dome, Remove the outer case

Setup

Mounting the Camera (continued)

Mounting on a ceiling (continued)

4. Remove the inner dome.

The inner dome is secured by 3 clips. Remove the inner dome from the clips.

5. Remove the outer case.

(The outer case is not used for this mounting method.)

A Loosen the camera fastening screws with a screwdriver.

BTurn the camera in the anti-clockwise direction and remove the outer case.

Connection

1. Mount the fall-prevention wire on the camera. This wire connects the camera to the ceiling.

2. Connect the LAN cable. (A Pg. 26)

3. Connect the power cable and the alarm cable. (A Pg. 24, 26)

Memo：

●The power cable must not be connected when PoE is used.

4. Wind the waterproof tape.

5. Insert the camera in the ceiling hole.

6. Remove the fall-prevention wire.

Remove the fall-prevention wire that is attached to the camera unit.

7. Loosen the pan fastening screw.

Note：

●The lens section may be damaged if you operate it without loosening the pan fastening screw.

Inner dome

47 Pan fastening screw

3

2

Fall- prevention wire(not

supplied) 4

Wind the waterproof tape.

3

Solder or crimp

Insulation tape

1

5 A Camera

Fastening

Screw

5 B	6
	Washer

18