| Outer case |
|
| mounting screw | |
| Less than 3 mm | |
1 | Towards | |
hook | 2 | |
| fastening | |
Mounting
1. Align the secured outer case with the position alignment mark of the camera.
Note：
●Make sure that the cables are not caught in the outer case.
2. Turn the camera in the clockwise direction.
RONTUP
F
Towards the shooting
direction
From the ceiling slab
3 T Loosensufficiently
TCheck that the ○ mark can be seen. (Refer to the diagram below)
3. Tighten the Camera Fastening Screws and secure the camera.
Position |
|
alignment |
|
mark |
|
1 | 2 |
T Check |
4. Connect the LAN cable. (A Pg. 26)
5. Connect the power cable and the alarm cable. (A Pg. 24)
Memo：
●The power cable must not be connected when PoE is used.
6. Wind the waterproof tape. (A Pg. 26)
45 Solder or crimp
Insulation tape
Wind the waterproof
6 tape.
Camera
Fastening
Screw
3
Image adjustment
When the camera is mounted, adjust the image settings while looking at the actual image.
(A Pg.27 eImage adjustmentf)
Mounting the Dome Cover
After the image adjustment is completed, mount the dome cover.
Installation is complete when the dome cover is mounted.
(A Pg.29 eMounting the Dome Coverf)
21
