Setup
Mounting the Camera (continued)
Mount by allowing the cable to exit from the side
You can also mount the camera on a ceiling or wall by pulling the cables horizontally instead of drilling a hole.
The basic mounting method is the same as eMounting the camera directly on a ceiling or alongside a wallf (A Pg. 20).
1. Remove the lid of the cable ejector hole and divide the dotted line section of the lid with a longnose pliers.
1
| Divide |
Cable ejector hole | 2 |
2. Mount the outer case on the ceiling or wall.
3. Pull out the cables from the cable ejector hole.
4. Connect the cables. (A Pg. 20)
5. Close the lid of the cable ejector hole.
5
Mounting the camera to the electrical box
Note：
●Before mounting the camera to electrical boxes, please refer to local building codes for box type to use for
Connecting
1. Align (j) with the shooting direction when mounting the outer case to the electrical box
| Outer case |
| mounting screws |
NT | ROUP |
| |
| F |
Less than 3 mm
Align with shooting direction
2. Follow steps 2 to 6 of AMount by allowing the cable to exit from the sideB[Connection]
(A Pg. 20)
22
