Anti-Shock Protection
This function minimizes sound interruption caused by vibrations, by utilizing audio data that has been stored in the memory ahead of the following time:
For Audio CD: Up to 45 seconds worth
For MP3: | Up to 120 seconds worth at 128 kbps |
Normally, the “A.S.P.” indicator lights up on the display and the
A.S.P indicator
When the disc is played, as the audio data gradually stored in the memory, the “A.S.P.” indicator changes from blinking to lighting:
[Fully stored]
To cancel the Anti-Shock Protection (Audio CD only)
Press the A.S.P./T.SEARCH button in stop mode or during playback.
The “A.S.P.” indicator goes out on the display.
To activate the
To activate the
Notes:
•The
•Turning off the
Using the unit with an audio system
Using a stereo connection cable (not included), you can listen to CDs through your audio system.
•Connect the cable to the amplifier after turning off its power.
•Do not connect the cable to the PHONO jacks on the amplifier.
•Obtain the optional connect ng cable if the amplifier comes with
•AdjustRightthesidevolumepaneleveloftheonunitthe amplifier(notStereoLINEOUTincluded).onnectionjackcable
(White)(Red) RLCD/AUXAmplifier
Notes:
• To obtain original sound, set HBS to “OFF”.
Preventing Accidental Operation (Hold) |
| Maintenance |
“HOLD ” indication | Maintaining the unit |
When the unit is in hold mode, “HOLD” will be displayed if a | Wipe the unit with a soft cloth. Remove stubborn dirt using a |
button is pressed. | cloth which has been dipped in water or soapy water and wrung |
| out, and then wipe dry. |
To release the function | • If you intend to use a chemically treated cleaning cloth, read |
Set the HOLD switch to OFF position. | its directions first. |
| • Do not use alcohol or paint thinners. |
The HOLD switch is prepared to prevent an accidental operation by an unexpected button press.
Setting the HOLD switch ON prevents the fol- lowing:
•Powering on the unit accidentally (which can cause the batter- ies to go dead).
•Play being cut off unexpectedly.
To set the unit in hold mode
• Set the HOLD switch to the ON position.
Note:
Before turning on the unit, be sure that HOLD is OFF. Otherwise, you cannot turn on the unit.
Maintaining the lens
Open the lid and clean the lens as shown in the figure. Use a cotton swab to gently wipe off any
Lens
Air blower for camera lens
Lens
5