JVC XL-PM20SL Power Supply Preparations, Location of Controls, Recharging procedure, Before use

Power Supply Preparations

Refer to the specifications (page 6) for information on operating times when using rechargeable batteries or dry-cell batteries.

When using rechargeable batteries

Be sure to recharge the rechargeable batteries BN-R1211 (not in- cluded) before using them.

For information about these, see “When purchasing rechargeable batteries” on page 6.

Recharging procedure

1 Insert the special rechargeable batteries into the unit.

Caution:

Do not open the battery lid too wide. It can break if you forcibly open it beyond approximately 90°.

2 Connect the AC adaptor.

AC power outlet

AC adaptor

Right side panel of the unit

DC IN jack (DC IN 4.5 V )

Recharging will be completed after 10 hours.

3 When recharging is complete, unplug the AC adaptor from the power outlet and the DC IN jack.

Notes:

•To operate the unit on batteries, the AC adaptor must be dis- connected from the DC IN jack.

•It takes approximately 10 hours to recharge the rechargeable batteries.

•Rechargeable batteries have a service life of approximately 300 charge-discharge cycles. If the operating time on one full charge becomes noticeably shorter than it used to be, the batteries have reached the end of their service life and should be replaced.

•Recharging takes place only when the unit is powered off. (It is not possible to recharge the batteries while playing a CD.)

•The AC adaptor and rechargeable batteries may become warm while recharging is in progress. This is normal and is not a mal- function.

If the battery lid	Removing batteries
compartment	Push up on the battery in
comes loose	the direction indicated by
Slide the lid back into	the arrow. Then lift it out.
place horizontally.

Using dry-cell batteries (not included)

After disconnecting the AC adaptor, insert two “R6” (LR6) alka- line batteries.

The procedure for inserting and removing dry-cell bat- teries is identical to that for rechargeable batteries.

Battery indicator

Battery indicator

The battery indicator changes as follows according to the remain- ing capacity of the battery.

Fully charged Low battery Empty

After a while the unit will turn off.

Rechargeable batteries: Recharge batteries.

Dry-cell batteries: Replace batteries with new ones.

Notes:

•The length of time the unit can continue further operation after the battery indicator changes to “ ” differs depending on the type of batteries used.

•The battery indicator may not be correctly displayed if rechargeable batteries, other than those designated by JVC, are used.

•When power is supplied from the AC adaptor, “ ” indicator always lights up.

Tip:

Turning off the Anti-Shock Protection (see page 5) will save the battery power more or less.

If the unit malfunctions or freezes during use, disconnect the power source (the AC adaptor and batteries). Then, connect the power source and operate the unit again.

Using the AC adaptor

Connect the AC adaptor supplied.

Refer to “When using rechargeable batteries” for connection in- structions.

Note:

The unit is in the standby condition when the AC adaptor is con- nected. The primary circuit is always “live” as long as the AC adaptor is connected to an AC power outlet.

AC adaptor (for multi voltage area only)

Before use

Make sure the present voltage of your AC adaptor fits to your lo- cal voltage before plugging it into the AC power outlet. If it doesn’t, shift the AC line-voltage selector with a screwdriver so that it corresponds to your local voltage.

VOLTAGE
ADJUSTOR
AC 110V	AC 220V
~127V	~240V

If the power plug will not fit your socket, use the AC adaptor.

How to use the AC adaptor

Location of Controls

A

Left side panel of the unit

B

Display

Portable CD player A Stereo headphones B

AStop / power off button (7)

BSkip / search buttons (4, ¢) C Play / pause button (3/8)

D Display

E MODE button

F A.S.P. (Anti-Shock Protection) /T.SEARCH (Title Search) button G PROGRAM buttonH GROUP button I LINE OUT jack

J Headphones jack ()

K Headphones volume control (VOLUME)L DC in jack (DC IN 4.5 V ) M Lid open switch (OPEN 3)N HOLD switch

O Hyper-bass sound switch (HBS)

2

1Battery indicator (See page 2.)2HBS (Hyper-Bass Sound) indicator (See page 4.)3 PROG (Program) indicator (See page 4.)4 A.S.P. (Anti-Shock Protection) indicator (See page 5.)5 (Search) indicator (See page 4.)6 GRP (Group) indicator (See page 4.)

7 MP3 indicator

Lights when an MP3 disc is used.8 Repeat indicator (See page 4.)

9INTRO indicator (See page 4.)

0RAND (Random) indicator (See page 4.) - CD-RW indicator

Lights when a CD-RW is used.