Bdabc C ef

Power Supply

Preparations

Using the AC adaptor

Connect the AC adaptor supplied.

aDC IN jack (DC IN 4.5 V ) b Right side panel of the unit

c AC adaptor

d AC power outlet

Note:

The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always “live” as long as the AC adaptor is connected to an AC power outlet.

Using dry-cell batteries (not included)

After disconnecting the AC adaptor, insert two “R6” (LR6) alkaline batteries.

The procedure for inserting and removing dry-cell bat- teries is identical to that for rechargeable batteries.

Using external battery case

Open the battery cover of the external battery case (sup- plied) and insert two “R6” (LR6) alkaline batteries (not included) into the battery compartment. Then, install the external battery case in the unit by turning the knob of the battery case.

eBottom of the unit

Battery indicator

fBattery indicator

This indicator lights when the batteries are almost out of power. Power is shut off a short while later.

Rechargeable batteries: Recharge batteries.

Dry-cell batteries: Replace batteries with new ones.

Notes:

The length of time the unit can continue further opera- tion after the battery indicator lights differs depending on the type of batteries used.

The battery indicator may not light if rechargeable bat- teries, other than those designated by JVC, are used.

Tip:

Turning off the Anti-Shock Protection (see page 29) will save the battery power more or less. (Available for an Au- dio CD only)

If the unit malfunctions or freezes during use, disconnect the AC adaptor and batteries. Then, connect the AC adaptor and batteries, and op- erate the unit again.

7

Page 10
Image 10
JVC XL-PM30SL Power Supply Preparations, Using the AC adaptor, Using dry-cell batteries not included, Battery indicator