Jwin JD-VD503 manual Intelligent Screensaver and STAND-BY Function

R

13. INTELLIGENT SCREENSAVER AND STAND-BY FUNCTION

With the same function of screensaver and stand-by function as computer, it will automatically enter into screensaver after three minutes under stop or no disc state, so as to protect your TV screen. It will automatically enter into stand-by state after twenty minutes of screensaver, then DVD display is not light, video has no output, power consumption of the appliance is largely reduced, so as to enhance the safety and prolong lifespan. In stand-by state, press "PLAY" or "OPEN/CLOSE" on the front panel of DVD to go normal working states.

14. MALFUNCTION & TROUBLESHOOTING

Before requesting after-sale warranty service, try the following troubleshooting suggestions..

No sound:

*Ensure that the player is properly connected with other systems, such as power amplifier or TV set.

*Ensure that TV set or power amplifier is working properly.

*Check if MUTE button of the appliance or TV set is pressed.

*Check whether volume of the TV set or player is adjusted to minimum.

No picture:

*Ensure that the player is connected firmly with the other system, such as TV set.

*Ensure that the TV set is working properly.

*Ensure that the video output mode is set properly (Refer to 4.3).

Disc not playing

*Ensure that the disc is placed correctly. (The label side is facing up.)

*Ensure that the disc is clean.

Microphone has no sound:

*Adjust the volume of the microphone to proper level.

Remote control does not work:

*Remove the obstacles between the player and the remote control.

*Point the remote control at the sensor on the front panel of the player.

*C h e c k w h e t h e r t h e e n e rg y o f t h e b a t t e r y i s adequate.

No display or partial display:

*Check whether the disc is scratched and ensure that the disc is clean.

*When there is trouble, please turn off the power because the appliance is controlled by microcomputer, and turn on the player again after several seconds. If the trouble is resolved, the player may work properly again.

No output after turning on the player:

*Ensure that the time interval between turning off and turning-on is not too short.

*Turn off the disc player, and turn on again after 10 seconds.

*Ensure that the video output mode is properly set. (Refer to 4.3 for details)

Screen is not light and no output

*T h e a p p l i a n c e m a y e n t e r t h e s t a n d - b y s t a t e . Press the "PLAY" or "OPEN/CLOSE" button on the panel to activate it.

*Switch off the power supply of the appliance, and turn it on after 10 seconds.

41