English | User Instructions | KMR 1250 B |
Replacing the main brush roller
n Park the sweeper and switch off the engine n Lower the brush roller.
nOpen the RH side flap 1 (seen in direction of travel).
n Undo the retaining bolt on the lower forked head 2 and swivel the push rod towards the rear.
n Unscrew the knurled knob 3.
n Remove the oscillating linkage 4.
n Open the flap over the end of the brush roller 5
nPull out the brush roller 6.
n Screw in the knob for adjusting the sweeping pattern as far as it will go (clockwise, towards
n Fit the new brush roller in reverse order to the removal procedure.
Brush roller seen from above |
Direction of travel |
Note:
Make sure the bristles point in the right direction – see illustration.
nSet up the sweeping pattern by turning the adjusting knob
– see “Adjusting the sweeping pattern”.
48
