English | User Instructions | KMR 1250 B |
Preparing the sweeper for use
All directions given (left/right, front/rear) are as seen from the driver’s seat.
nCheck the oil level in the engine (see Chapter: “Mainte- nance”).
nCheck the amount of fuel in the tank and fill up, if required (see below).
nCheck the level of hydraulic fluid and top up, if required (see Chapter: “Maintenance”).
nCheck the air pressure in the tyres (see Chapter: “Maintenance”).
nInspect the brush roller and remove any string, rope, etc., that may be caught up in the brushes.
nCheck the dust filter. If it is very dirty, operate the shaker to clean it off.
nEmpty the waste container.
Adjusting the driver’s seat
The driver’s seat can be adjusted to suit persons of various heights.
nUnhook the rods in the seat tilting device. ç Undo the 4 screws.
nMove the seat to the desired position.
nTighten the screws and hook the rods back into the tilting device.
Filling the fuel tank
!Explosion hazard while refuelling!
n Do not fill up with fuel
– in an enclosed space
– while the engine is running.
n Do not smoke while refuelling the vehicle. n Fuel expands as it becomes warmer.
Do not fill the tank right up to the top. Leave a gap of at least 1 cm under the bottom edge of the filler neck.
n Wipe up any fuel they may have been spilt and ensure that the cap is replaced firmly on the tank.
n Use petrol, regular
Opening the fuel tap
n Open the unit cover. ç Open the fuel tap.
OPEN = lever pushed to side opposite to direction of travel
n Close the unit cover.
34
