KMR 1250 D | User Instructions | English |
Prior to initial | Unloading procedure |
|
| Do not use a forklift truck for unloading as it could | |
!cause damage to the sweeper.
The sweeper has been lashed onto a pallet to ensure that it can be transported safely. The procedure for unpacking the sweeper is as follows:
1. Remove the wooden boards from the pallet and nail them onto the end of the pallet (in front of the sweeper).
2. Detach the wires holding the sweeper in place at the ends of the pallet.
3. Knock away the blocks used for locking the wheels and use them for the support of the wooden planks on the left and right.
4. Drive the sweeper off the pallet and down the ramp made from the boards.
5.The side brush has been tied to the chassis for trans- port. Undo the cord holding it in place.
Pushing the sweeper by hand
If you wish to move the sweeper without using its own drive:
nOpen the engine cover.
n Fold the cover towards the rear; it will be held in place by the pneumatic spring.
ç Turn the lever for allowing freewheeling to position "OFF".
nRelease the handbrake.
nPush the sweeper to the required destination.
Note:
Do not push the sweeper over long distances or move it at a speed greater than 10 km/h (e.g. when it is being towed).
After moving the machine
nPut the parking brake on.
nSet
31
