Karcher KMR 1250 D manual Cleaning the filter, Braking, Stopping the sweeper and switching off

KMR 1250 D User Instructions English

Cleaning the filter

Braking

nRelease the drive pedal and the sweeper will brake auto- matically.

Important note: Safety!

It is possible that the automatic braking function will not be sufficient to bring the sweeper to a halt. In this case, either make use of the parking brake as well or gently press the drive pedal in the opposite direction to travel.

Stopping the sweeper and switching off

nRelease the drive pedal. The sweeper brakes automati- cally and comes to a halt.

nApply the parking brake .

nSet the throttle lever to minimum engine speed (to the rear).

nMake sure the main roller and side brush are raised so that the bristles are not damaged.

nSwitching off

–Turn the ignition key counter-clockwise to the 0 positi- on and then remove it.

After the engine has been switched off, the filter is automatically cleaned for approx. 10 seconds.

Automatic cleaning

nStop the sweeper and switch off the engine.

After the engine has been switched off, the filter is auto- matically cleaned for approx. 10 seconds.

Manual cleaning

While the sweeper is operating, the filter should be cleaned approx. every 15–30 minutes (depending on amount of dust).

nStop the sweeper.

n	Set the sweeping mode lever to wet	.
n	Give a short press on the filter cleaner button		, the

filter is cleaned for about 10 seconds. .

n Set the sweeping mode lever back to dry .

nContinue with cleaning task as before.

35