SEARCH CHANNELS (CHANNEL SEARCH)
MANUAL (CHANNEL) SEARCH
The buttons allow you to select different sets of parameters for the search.
Start frequency
Use the buttons to select the start frequency for the search.
Stop frequency
Use the buttons to select the end frequency for the search.
Channel Search Mode
Use the buttons to select whether you wish to search “free and scrambled” or “only free” channels.
Network Search
Use the buttons (On/Off) to select whether a network search should be performed. If you set this to “On”, the networking of the transmission channels enables additional transmission channels that have not yet been saved to be located. They are then saved and searched for new channels in the same way as the existing channels.
If you set this to “Off”, only the
When you have made your settings, use the buttons to select “Start Search” and press the button to start searching. You can cancel the search at any time by pressing the button.
During the search you will see a display that shows you the progress of the search and the channels found so far. Newly found channels are identified with the designation “New” after the channel name.
42
