CONNECTION AND SETUP

The serial number sticker for the UFC 662sw is located on the underside of the unit.

The information printed on it includes the following:

-the exact designation (e.g. UFC 662sw)

-the part number and

-the serial number of the unit.

You do not need this information in order to operate the unit. If however, contrary to expectations, you need to make a claim under warranty and you do not have the packaging for the receiver to hand, you can find the above information about the unit on this sticker.

The following section is intended specifically for specialist dealers. You need not refer to this section unless you are carrying out the installation yourself.

The “Connection examples” section provides a sample configuration.

Do not connect the receiver to the power supply until all installation work has been properly carried out. Refer to the information in the “Safety instructions” section.

CONNECTING THE RECEIVER

Connect the RF input of the receiver to the antenna socket. For this, use a coaxial cable with a plug to with the F standard or the IEC standard (in combination with the F adapter supplied with the receiver).

If the IEC connector is not yet fitted to the cable, strip the insulation from the cable as shown in the following illustration and carefully fit the connector on to the end of the cable so that it is securely fitted.

Fitting a plug to the

“F” standard

Fitting a plug to the

 

“IEC” standard

 

Lengthwise slits (3x)

Bend back

Screw together

When fitting the connector, make sure that no wires from the braid are touching the inner conductor, otherwise a short circuit will occur.

The quality of the reception signal depends on this connection!

11

Page 11
Image 11
Kathrein UFC 662sw manual Connection and Setup, Connecting the Receiver, Fitting a plug to