Kathrein UFC 662sw manual TV and VCR Connection, Audio Connection, Electrical Digital Output

CONNECTION AND SETUP

TV AND VCR CONNECTION

Connect the cable receiver (HDMI or alternatively TV Scart socket) and the TV set using an HDMI or Scart cable (see “Connection example”). If your TV is stereo, you can receive the sound in stereo via the HDMI or Scart connection.

For system reasons, the same video signals are to be found at the TV Scart socket as at the video cinch output.

Use a Scart cable to connect the cable receiver (TV Scart socket) to the video recorder/PVR.

Connecting a video recorder/PVR to the TV Scart socket allows you only to record. It does not allow you to play back on the TV set via the receiver. If you are recording via an external video recorder/PVR, remember not to operate the receiver during recording, otherwise all the on-screen displays will appear on your recording.

AUDIO CONNECTION

If you want to play the sound on your hi-fi system, connect the audio cinch sockets to the input sockets on the hi-fi system, using an appropriate cable (see “Connection example”).

ELECTRICAL DIGITAL OUTPUT

The electric digital output is intended for the connection of a Dolby Digital system (see “Connection example”).

INSERTING BATTERIES INTO THE REMOTE CONTROL

Remove the cover on the rear of the remote control. Insert the two batteries supplied into the remote control. Ensure correct polarity of the batteries; the + and – markings as indicated inside the battery compartment. Slide the cover back onto the housing until it locks in place.

13